Toate traducerile

Suit un panorama mouvant, brossé à grands traits, dont l'impressario, armé de sa baguette démonstrative, doit expliquer au public les principaux sujets: -- Traversons la vallée du San Miguel et de l'Atascosa. Sur ce petit promontoire escarpé, le chalet qui se cache au milieu des cèdres était l'épicerie du canton.

Çok düşündüm ama bilmiyorum . Sanırım bunun için birlikte zaman geçirmeliyiz.

Qu’est-ce qu’un coup d’Etat ? C’est le remplacement d’un pouvoir légitime, issu du peuple, par un pouvoir qui ne l’est pas.


Le transfert, en toute illégalité, à des autorités européennes et internationales qui ne sont soumises à aucun contrôle démocratique de pouvoirs qui relèvent par nature de la souveraineté populaire s’apparente à un véritable coup d’Etat.


Les gouvernants qui sont à la manoeuvre manifestent leur plus total mépris du respect des exigences démocratiques. Par des artifices de procédure, en interprétant abusivement des règles dont ils se moquent, ils se font les complices d’une entreprise de démantèlement de la démocratie et d’effacement d’un acquis fondamental dans l’histoire de l’humanité : la souveraineté du peuple.

e) Use a file/cutters to cut a chunk out of the case above the screen for the 9 pin sub-D connector to be mounted. I recommend the female version because if you use a male connector one day some dope will plug a joystick into it and break something. When filing/drilling the case, place some tape around the edges of the screen opening to prevent plastic filings from getting trapped behind the plastic. Assign one of the pins on the sub-D as the 'ground' pin and solder a wire between it and the outer metal shell (or just wrap it around the screw).

f) Next, make a DE9 -> SCART cable. If you have an RGB monitor you might want to substitute whatever it uses in place of the SCART. I built mine by cutting the end off a three meter long RS-232 (male on one end, female on the other) serial cable and attaching a male SCART connector. I find this works well but I do get a small bit of 60Hz hum in the audio from the video signal getting into the audio through signal cross talk. The only way to eliminate this would be to run the audio through a separate, shielded cable. A SCART pinout can be found here, decide on your own pinout for the D9 connector and write it down! Connecting the CVBS status line (SCART pin 8) is optional but may be required for some TVs to enter A/V mode.

g) Blow out all the dust, put the guts back in and solder wires to the 9 pin D connector and to the various places on the main board. When everything is soldered in place (and all wires double checked) plug everything in, power it up, and see what happens. Hopefully the game (you put a game in, right?) is playing on the TV. The game gear has a lot of noise on its power supply rails. In my game gear this noise got into the video amplifiers and appeared as interference in the picture. To remove this I recommend putting an inductor in series with the +5v line that feeds our little board. This inductor should have 10�H or greater inductance and no more than an ohm or so of resistance. I used a 22�H RF choke.

h) When everything is tested and found to be working, place a strip of electrical tape along the PC under the cartridge slot. Then place our modification board on top and hold it in place with hot glue along the sides. If something goes wrong later the board can be easily removed by cutting the hot glue.

Ils participent à l'augmentation des prix des denrées de base. L'an dernier, les Etats Unis ont "brûlé" 138 millions de tonnes de maïs pour en faire du bioéthanol. Un plein de 50 litres de bioéthanol consomme 350 kg de maïs, ce qui ferait vivre un enfant mexicain ou zambien pendant un an.

ままのいうとうり４ねんせいになってべんきょうもむずかしくなり
メールがおくれませんでした
でもパパのかんちがいが１つあります
それはフランスをおもいでのくにとはおもっていません
でもすこしにほんがすきです
ごめんなさい
これから１しゅうかんに１かいはかならずメールをおくるようにします
でもにほんごをたくさんつかってしますいます。
ごめんなさい

1 Construction
Download the Part Layout and Wiring Diagram and print it out (it might be a good idea to trace the wires with coloured pens if you don't have a colour printer). All parts required to build this circuit are available from Jaycar Electronics. Their range isn't very big so hopefully it should be easy for anyone to obtain the parts locally from suppliers with a similar basic range.
I'm aware of two internally different versions of Game Gear. The newer and by far the most common one is the single ASIC (Sega chip) version. The earlier version contains two ASICs and more ram chips. Here are some photos to aid in locating various signals on the board (though the circuit diagram should be sufficient for people who can read it). The power rail (+5v and ground) can be picked off a nearby filter capacitor.
The circuit will be constructed on a piece of matrix style proto-board (not verroboard, though the verro mob probably make it too). It's a phenolic board with a grid of 0.1" holes punched and a single copper pad for each hole on the solder side. To fit all logic ICs on the board we're going to take advantage of the fact that some of the ICs have many pins connected in parallel, and stack them on top of each other. This method saves lots of space and lots of wire. This is important because not only do we save many cents which would have otherwise been wasted on board and wire, but we can also fit the circuit board into the small empty void below the Game Gear's cartridge slot.
Procedure

Here's a step-by-step (ok, more like jump-by-jump) pictorial guide to the construction and installation of the video amplifier/DAC board. This isn't intended to by a 'my first circuit' type of project - good soldering skills are required.

It's much easier to stack and solder the chips before they're on the board. Cut off unrequired outputs, join required inputs and bend out the pins on the 74HC374 first and second stories for the resistors. It's clear in this picture that I've forgotten to bend out the pin 11 clock input. On the left is the double stack of HC74s. Notice that I've connected the inputs of the unused half of the top chip to the inputs of the bottom chip, not +5v as shown on the circuit. I find it's easier this way, it doesn't really matter where they are connected as long as they are not left floating.
2 Chop up the proto-board into a piece 11 holes high and 30 holes wide. Solder the resistors onto the HC374 tower, stuff the rest of the ICs + bypass/filter capacitors on the board and we have something that looks like.
3 Now's the time to wire up the power supply lines to each chip. Once that's done all the logic wiring between the ICs needs to be taken care of. Keep the wires short and neat.
4 The final part, the video amplifier, is added in the middle. This connects to the isolated pads mid right in the picture above. Each input/output each need a wire soldered to it and poked up through an adjacent hole.
5 (Will come later)

New Updates are Ready!
Do you want to download the updates?
Downloading updates.
Download successful!

This feature is not available on the free version.
No connection.
Please check your internet connection.
Message posted.

“- Cine ți-a cerut așa ceva? se minună Rotaru.
- Nimeni! Și totuși, dacă aș scoate gazeta pe care inima mea o poftește, ar trebui să intru în solda cine știe cui, fiindcă n-am bani! mărturisi Toma. Dumneata însuți îmi faci imputări, dar niciodată nu mi-ai oferit sprijinul...Iartă-mă că ți-o spun!
- Dar nici tu nu mi l-ai cerut, Tomiță! zise zâmbind Rotaru. De altfel, nu poți oferi ceea ce n-ai! Eu nici nu mă pricep în ziaristică, și nici bani nu am atâția cât se pare că poate înghiți un jurnal.”

Birisiyle iliÅŸkiye girmedim.

The linguistic form of the translation is fine but I need the opinion of the community to be sure that the meaning is right.

Bonjour... Comment allez-vous aujourd'hui?
Aimez-vous les très belles jeunes filles?

Elle se demandait s'il n'y aurait pas eu moyen, par d'autres combinaisons du hasard, de rencontrer un autre homme; et elle cherchait à imaginer quels eussent été ces événements non survenus, cette vie différente, ce mari qu'elle ne connaissait pas. Tous, en effet, ne ressemblaient pas à celui-là.

After my first visit to Boston, I spent almost every winter in the North. Once I went on a visit to a New England village with its frozen lakes and vast snow fields. It was then that I had opportunities such as had never been mine to enter into the treasures of the snow.

I recall my surprise on discovering that a mysterious hand had stripped the trees and bushes, leaving only here and there a wrinkled leaf. The birds had flown, and their empty nests in the bare trees were filled with snow. Winter was on hill and field. The earth seemed benumbed by his icy touch, and the very spirits of the trees had withdrawn to their roots, and there, curled up in the dark, lay fast asleep. All life seemed to have ebbed away, and even when the sun shone the day was

Shrunk and cold,
As if her veins were sapless and old,
And she rose up decrepitly
For a last dim look at earth and sea.

The withered grass and the bushes were transformed into a forest of icicles.

Down by the river by the boats
Where everybody goes to be alone
Where you won’t see any rising sun
Down to the river we will run

When by the water we drink to the dregs
Look at the stones on the riverbed
I can tell from your eyes
You've never been by the Riverside

Down by the water the riverbed
Somebody calls you somebody says
swim with the current and float away
Down by the river everyday

Oh my God I see how everything is torn in the river deep
And I don't know why I go the way
Down by the Riverside

When that old river runs past your eyes
To wash off the dirt on the Riverside
Go to the water so very near
The river will be your eyes and ears

I walk to the borders on my own
To fall in the water just like a stone
Chilled to the marrow in them bones
Why do I go here all alone

Down by the Riverside

Qu'aucune heure ne s'écoule dont tu ne veuilles garder le souvenir.

Oui. Une dizaine de grandes sociétés transcontinentales tiennent ce marché mondial des matières premières alimentaires. Cette spéculation n'épargne d'ailleurs pas les petits paysans français et européens. Mais elle affame les plus pauvres du monde. Il faudrait donc d'urgence interdire la spéculation sur tous les produits de première nécessité.